This series of projects is a collaboration of site specific installation and wearable objects.
Photoshop sketches:
Brooch for intsallation below
Plastic models for installation, third generation
Wax masters - third generation
Ring for Installation below
Samples
silicone mold of ring shank
Smooth on silicon mold, 27 T hardness/ clear
poured bee's wax, not a good idea, cannot carve
These are plastic molds i cast from the bronze master. They said it couldn't be done! but it has!
Rosewood from Rockler
Electroformed wax models
Carved Balsa model
Basswood and cherry models
Plastic Spoon models!!
Altered with clay and then cast in plaster mold
Plastic spoons after I made plaster molds. Each Plastic spoon was enhanced with clay and then molded.
I used purple carving injection wax to pour each mold.
The injection wax was better to carve but still sticky. 
possible layout for brooch
As of now I have made 6 master waxes to be molded again and cast in plastic
Plastic reside from pouring. I think it looks rad.
Sketch of brooch for 1st installation
images of inspiration and patters to follow
No comments:
Post a Comment